Ugears Drift Cobra is a stylish two-seat convertible with front wheels turning and doors opening. It also features a hood and trunk which you can raise. A powerful spring motor puts the Ugears Drift Cobra ahead of any rival model car. First move the air filter protruding from the hood to the windshield, then put the switch located in front of the passenger seat parallel to the door (into the ‘Lock’ position). Wind a ratchet knob located under the chassis. You don’t need to hold the knob all the time when you wind it. The knob the spring is fully loaded after about six turns and your automobile is ready for action! Like in a real car, the lever for shifting gears can be put in Drive, Reverse or Neutral position. A powerful spring is used intead of a customary rubber band, which means the car is able to go further and has a longer usability than similar models.Place your Cobra on a flat surface, slide the air filter forward, and observe your car perform spin outs (turn the wheels to one side before putting the model in motion), go in circles, or race away in a straight line (of up to eight meters !).

The DIY Drift Cobra Racing Car kit consists of 370 parts, requires approximately nine hours to assemble, and is considered just right for Advanced level model enthusiasts. All the components for bringing one of the most recognizable cars to life come in the box: precisely-cut high quality plywood pieces (put together without glue or special tools), a metal spring powering the engine, and a set of detailed illustrated instructions in eleven languages.